3,626 research outputs found

    Loop Corrections to the Neutral Higgs Boson Sector of the MSSM with Explicit CP Violation

    Full text link
    We compute one-loop corrections to the mass matrix of the neutral Higgs bosons of the Minimal Supersymmetric Standard Model with explicit CP violation. We use the effective potential method, allowing for arbitrary splitting between squark masses. We include terms O(g^2 h^2), where g and h stand for electroweak gauge and Yukawa couplings, respectively. Leading two-loop corrections are taken into account by means of appropriately defined running quark masses.Comment: LaTeX, 12 pages incl. 3 figures. V.2: slightly rewritten to allow for a more general phase convention. Fixed some typos and added one referenc

    Woven fabric carbon fibre composites hybrid joints under quasi-static testing

    Get PDF
    Twill weave carbon fibre reinforced polymer (CFRP) hybrid adhesively bonded-bolted joints was investigated on bearing stress at failure in experimental programmes. The present paper comprises effects of joint type, normalised coupon width (W/d), laminate orientations and bolt load as specified in designed series. All CFRP hybrid joints exhibited cohesive failure before ultimate failure i.e., net-tension and bearing/net-tension failures. Bearing stress at failure was found to increase with normalized W/d and small W/d led to net-tension failure occurrence. Double-lap joints (DLJs) were stronger than single-lap joints (SLJs) due to secondary bending phenomenon in SLJs. Cross-ply presented greater strength than quasiisotropic lay-up caused by the presence of 0Ëš fibres orientation. Clamped condition (applied torque, T = 5 Nm) may change the critical W/d than finger-tight (FT) case as net-tension failures is likely to occur under clamped condition

    Temperature- and magnetic-field-dependent resistivity of MgB2 sintered at high temperature and high pressure condition

    Full text link
    We report the temperature- and magnetic-field-dependent resistivity of MgB2 sintered at high temperature and high pressure condition. The superconducting transition width for the resistivity measurement was about 0.4 K, and the low-field magnetization showed a sharp superconducting transition with a transition width of about 1 K. The resistivity in the normal state roughly followed T^2 behavior with smaller residual resistivity ratio (RRR) of 3 over broad temperature region above 100 K rather than reported T^3 behavior with larger RRR value of ~ 20 in the samples made at lower pressures. Also, the resistivity did not change appreciably with the applied magnetic field, which was different from previous report. These differences were discussed with the microscopic and structural change due to the high-pressure sintering.Comment: 2 pages, 3 figures. Accepted by Physica

    Mammalian Evolution: A Jurassic Spark

    Get PDF
    SummaryThere is increasing evidence that early mammals evolved rapidly into a range of body forms and habitats, right under the noses of the dinosaurs

    A Study on the Sexual Dysfunction of Female Recipients Who Underwent Hematopoietic Stem Cell Transplantation

    Get PDF

    P197 THE EFFECTS OF SYNTHETIC TRITERPENOIDS ON SZP SYNTHESIS IN ARTICULAR CHONDROCYTES

    Get PDF

    Model Predictive Direct Current Control (MPDCC) for Grid Connected Application

    Get PDF
    This paper deals with the design and simulation of Dual Active Bridge Multilevel Inverter (DABMI) based Model Predictive Direct Current Control (MPDCC) for grid connected application. To achieve multilevel output voltage waveforms, the second inverter will be supply with half of the dc-link voltage. Model predictive direct current control used to control the grid current component in order to achieve minimum grid current error. Modulation is unnecessary in this system because the switching pattern is produce by the possible switching that determined by the proposed MPDCC. The voltage vector which minimizes the cost function will be selected and applied to track the reference current. The performance of the proposed MPDCC is observe and implement by MATLAB/Simulink Software

    Probing MSSM Higgs Sector with Explicit CP Violation at a Photon Linear Collider

    Get PDF
    The CP properties of Higgs bosons can be probed through their s-channel resonance productions via photon-photon collisions by use of circularly and/or linearly polarized backscattered laser photons at a TeV-scale linear e^+ e^- collider. Exploiting this powerful tool, we investigate in detail the Higgs sector of the minimal supersymmetric Standard Model with explicit CP violation.Comment: 18 pages, 5 figures. Some comments added and typos corrected. To appear in Phys. Rev.
    • …
    corecore